Cooling System - Air or Combustion Gas Test C Series Page 8-32 Section 8 - Cooling System - Group 08 Install a pressure cap that has the spring and the pressure relief valve removed to allow free flow from the overflow tube. Attach a rubber hose to the radiator overflow connection. Put the free end of the hose below the water level in a container of water. NOTE: The pressure cap must be tightly sealed in the top of the radiator fill neck. NOTE: A gasket may need to be installed in order to properly seal this interface. If the pressure cap is not properly sealed then any air bubbles that may be present will not show up during the test.
Operate the engine at rated rpm until it reaches a temperature of 82°C [180°F]. Check for air bubbles in the water container. A combustion gas leak is present if a continuous flow of air bubbles is present or air is entering the coolant system. NOTE: The engine coolant temperature must be stable to perform this test. An increasing coolant temperature will give a false indication of air because of the expansion of the coolant in the system. A continuous flow of air bubbles may indicate one of the following: A cylinder head combustion gas leak Incorrect cylinder liner protrusion Cracked or broken cylinder liners Damaged aftercooler.
Combustion Gas Leak Use combustion gas tester, Part Number 3822985, to test for combustion gases in the cooling system. NOTE: It is recommended that the cooling system contain a premixture of 50-percent antifreeze and 50-percent water during the combustion gas leak test. The use of water only can result in a color change in the test fluid from blue to turquoise or light green during the test. This is not an indication of a combustion gas leak.