C Series Cooling System - Air or Combustion Gas Test Section 8 - Cooling System - Group 08 Page 8-33 Do not remove the pressure cap from a hot engine. Wait until the coolant temperature is below 50°C [120°F] before removing the pressure cap. Heated coolant spray or steam can cause personal injury. WARNING Coolant is toxic. If not reused, dispose of in accordance with local environmental regulations. WARNING Drain the coolant level down approximately 50 mm [2 in] below the radiator cap seal ledge in the radiator fill neck. Refer to Procedure 008-018 in Section 8. Pour the test fluid into the combustion gas test instrument until it is up to the yellow fill line on the instrument.
Insert the rubber tip of the combustion gas leak test instrument in the radiator fill neck. Hold the instrument down firmly and turn back and forth to make sure that an airtight seal is formed between the tester and radiator fill neck. Start the engine and operate at high idle for approximately 30 minutes. Monitor the engine temperature and color of the test fluid during engine operation. Do not allow the engine temperature to exceed 100°C [212°F] during the test.