Fan Drive Idler Pulley Assembly C Series Page 8-36 Section 8 - Cooling System - Group 08 NOTE: If the cooling system is contaminated with oil, it must be cleaned and flushed. Refer to Procedure 008-018. The operating pressure of the cooling system and the lubricating system can result in the mixing of the fluids if there is a leak between the systems: head gasket and oil cooler. Transmission fluid can also leak into the cooling system through transmission oil coolers. Engine Coolant Heater (008-023) Maintenance Check If your engine is equipped with an optional coolant heater, it should be checked periodically, especially when cold weather nears.
When operating, the engine block heater will make an audible sound and the engine block will be warm to the touch in the water jacket areas. The coolant heater works on shore power. Fan Drive Idler Pulley Assembly (008-030) Preparatory Steps Remove the drive belt; refer to Procedure 008-002. Service Tip: Loosen the capscrews before removing the belt, and tighten the capscrews to the proper torque specification after the belt is installed. Remove Remove the four capscrews, fan, and spacer.