Sea Water Pump C Series Page 8-46 Section 8 - Cooling System - Group 08 Open the sea water valve on the vessel hull. Operate the engine and check for leaks. Sea Water Pump (008-057) Preparatory Steps Shut off the sea water inlet valve on the vessel hull. Remove the inlet and outlet hose and drain the water from the pump. Remove CAUTION If the impeller has failed and pieces are missing, all pieces must be retrieved. The engine heat exchanger, gear oil cooler, and sea water aftercooler (if equipped) must be flushed. Refer to the procedures for flushing these components in other headings of this section. Failure to do so can result in overheating and damage to engine can occur.
Impeller debris can also drop into the inlet piping. Make sure all debris is removed before installing a new impeller; otherwise, additional impeller failures or engine overheating will occur.