C Series Sea Water Pump Section 8 - Cooling System - Group 08 Page 8-47 Remove the capscrews. Lift off the cover. Use a small screwdriver to remove the o-ring (A). Use a small screwdriver to remove the inner cap (B). Clean the o-ring groove. Do not pry against the pump housing to remove the impeller as this can cause damage to the liner. CAUTION Be sure to note the direction of impeller fins for proper re- installation. Mark the outer surface. An impeller removal tool is available from Sherwood Pumps, Part Number 23631. If the impeller is equipped with a threaded insert, use the special tool or a ѕ-NFT bolt (1) to insert in the impeller to pull the impeller out.
Be sure to note the direction of impeller fins for proper re- installation. Mark the outer surface. If the impeller does not have a threaded bore, grasp the hub of the impeller with pliers and remove the impeller from the impeller bore.