Cummins — 3666003

Aftercooler Assembly C Series Page 10-4 Section 10 - Air Intake System - Group 10 Clean Clean the aftercooler housing sealing surfaces. Keep the gasket material and all other materials out of the intake manifold. Install Use silicone sealant, Part Number 3823494, on both sides of the aftercooler housing gasket. Install the aftercooler housing and new gasket. NOTE: For aftercoolers with a form-in-place gasket, apply a 4-mm bead of sealant to the cylinder head. Install and tighten the aftercooler housing mounting capscrews. Torque Value: 24 N•m [ 18 ft-lb ] Install the coolant supply tube (1) and coolant return tube (2). Torque Value:

5 N•m [ 44 in-lb ] Finishing Steps CAUTION During filling, air must be vented from the engine coolant passages. Open the engine vent petcock. Make sure to open the petcock on the aftercooler for aftercooled engines. The system must be filled slowly to prevent air locks. Wait two to three minutes to allow air to be vented; then add coolant to bring the level to the bottom of the radiator filler neck. Connect the cold starting aid, if used. Refer to the OEM service manual. Install the air crossover tube. Refer to Procedure 010-019. Fill the cooling system. Refer to Procedure 008-018.