Cummins — 3666003

Charge-Air Cooler C Series Page 10-10 Section 10 - Air Intake System - Group 10 3. Turbocharger-to-exhaust-manifold mounting gasket Replace the gasket. Refer to Procedure 010-033. Operate the engine at full throttle and rated rpm under maximum load conditions. Listen for leaks. Replace the turbocharger if the air piping is not damaged and the noise can still be heard; refer to Procedure 010-033. Charge-Air Cooler (010-027) General Information The long-term integrity of the charge-air cooler system is the responsibility of the vehicle and component manufacturers; however, the following can be checked by any Cummins® Authorized Repair Facility. NOTE:

If the engine experiences turbocharger damage or any other occasion where oil or debris is put into the charge-air cooler, the charge-air cooler must be cleaned. Initial Check Inspect the charge-air cooler for cracks, holes, and other damage. Inspect the tubes, fins, and welds for tears, breaks, or other damage. If any damage causes the charge-air cooler to fail the air leak check, the charge-air cooler must be replaced. Inspect the charge-air cooler plumbing for cracks and damage.