Charge-Air Cooler C Series Page 10-12 Section 10 - Air Intake System - Group 10 When using solvents, acids, or alkaline materials for cleaning, follow the manufacturer's recommendations for use. Wear goggles and protective clothing to reduce the possibility of personal injury. WARNING Wear appropriate eye and face protection when using compressed air. Flying debris and dirt can cause personal injury. WARNING The charge air cooler must be rinsed, dried, and cleaned of solvent, oil, and debris, or engine damage will result.
CAUTION After the charge-air cooler has been thoroughly cleaned of all oil and debris with solvent, wash the charge-air cooler internally with hot, soapy water to remove the remaining solvent. Rinse thoroughly with clean water. Blow compressed air through the inside of the charge-air cooler in the opposite direction of normal airflow until the charge-air cooler is dry internally. Install Install the charge-air cooler. Install the charge-air cooler plumbing. Refer to the OEM service manual for instructions. Pressure Test Install the pressure gauge, Part Number ST-1273, or equivalent, to the fitting in the turbocharger outlet.
Install another pressure gauge, Part Number ST-1273, or equivalent, in the intake manifold. Operate the engine at rated rpm and load. Record the readings on the two gauges. If the differential pressure is greater than 21 kPa [3 psi], check the charge-air cooler for plugging. Clean or replace if necessary.