C Series Turbocharger Wastegate Actuator Section 10 - Air Intake System - Group 10 Page 10-27 Remove the retaining clip from the control lever. Disconnect the boost capsule actuator rod end from the turbocharger wastegate lever. This can be accomplished by applying regulated air pressure to the boost capsule in a sufficient amount to activate control rod movement. Disconnect the control rod from the turbocharger wastegate lever pin. NOTE: If the boost capsule diaphragm material is ruptured and will not hold air pressure other than by hand, manually pull the control rod outward to overcome boost capsule spring tension for removal of the control rod from the turbocharger wastegate lever pin.
Loosen the boost capsule mounting capscrews, disconnect the air supply hose, and remove assembly from the mounting bracket. Record the length of adjusting link prior to removal. Loosen the nut and remove the adjusting link end from the boost capsule actuator. Inspect for Reuse Inspect the wastegate actuator hose for cracks or holes. Replace the hose if damaged.