Cummins — 3666003

Turbocharger Wastegate Actuator C Series Page 10-28 Section 10 - Air Intake System - Group 10 Inspect the wastegate mounting bracket, actuator rod, and lever for damage. A bent wastegate mounting bracket, actuator rod, or lever can cause improper operation. If the wastegate mounting bracket, actuator rod, or lever is bent, it must be replaced. Pressure Test Connect regulated air pressure and an accurate pressure gauge to the capsule. Apply 180 kPa [26 psi] to make sure the wastegate is functioning properly. The actuating rod must move approximately 5 mm [0.2 in] without any sticking or air leakage. NOTE:

A small amount of travel when air pressure is first applied is normal; the tolerance is being removed from the system. Replace the actuator if no movement of the actuator rod and lever is detected. If repair is not correct, refer to Turbocharger Wastegate Actuator - Calibration in this section. Install Install the adjusting link end onto the boost capsule actuator assembly. Adjust the rod to approximately the same length as when removed.