Cummins — 3666003

C Series Turbocharger Wastegate Actuator Section 10 - Air Intake System - Group 10 Page 10-29 Fit the new boost capsule actuator assembly to the actuator mounting bracket, and install the mounting capscrews. Torque Value: 4.5 N•m [ 40 in-lb ] Calibrate NOTE: The wastegate is set accurately from the factory. Adjustment is not necessary unless the capsule is removed. Connect clean, regulated air pressure to the boost capsule. Regulate the air pressure to the wastegate capsule according to the following table. Pressure (psi) '96 190 to 230 Automotive 198 29 Model Year Rating (hp) Application Pressure (kPa) Measure the actuator travel:

Wastegate Actuator Travel Measurement mm in 0.33 MIN 0.013 1.30 MAX 0.051 Do not pull, push, or force alignment of the clevis pin. This can damage the wastegate. CAUTION Adjust the wastegate, if necessary, to achieve specified travel. Pull the wastegate lever to the foremost closed position (lever toward boost capsule). Adjust the length of the clevis end of the control rod to where the clevis pin hole aligns to the wastegate lever. Install the adjusting link and retaining clip. After adjustment is complete, tighten actuator rod jam nuts.