Cummins — 3666003

Intake Manifold Pressure C Series Page 10-30 Section 10 - Air Intake System - Group 10 Disconnect the regulated air pressure line from the boost capsule. Connect the turboboost line to the boost capsule, and secure with hose clamps. NOTE: If possible, a more accurate method of wastegate adjustment is to inspect the manifold pressure at rated rpm. Intake Manifold Pressure (010-057) Measure Measure boost pressure at the intake manifold. Use one of the tapped or plugged intake access holes shown in the illustration. Refer to the specifications in Procedure 018-019 (Air Intake System) in Section V. If the specifications for the engine are not listed, see the engine data sheet. NOTE:

If the engine has charge-air-cooling, the charge- air-cooler must be tested for leaks and turbocharger boost pressure restriction. Refer to Procedure 010-027 (Charge-Air Cooler) in Section 10 for charge-air-cooler testing. Exhaust leaks can typically be detected audibly, or visually by a discoloration caused by escaping hot gases. Exhaust restriction can cause low power. If exhaust gases can not flow freely, the turbocharger will not operate efficiently.