Intake Manifold Air Heater Wiring Harness C Series Page 10-34 Section 10 - Air Intake System - Group 10 Check the voltage to the heater control module. The WAIT TO START lamp, if equipped, will stay on if there is no voltage to the heater control module. If there is no WAIT TO START lamp, check the voltage at the resistor in the supply wire from the fuse to the heater control module. If no voltage is present, repair the wiring harness. Refer to the wiring diagram. If voltage is present, check the resistor with an ohmmeter. Replace the resistor if necessary. Resistance: 15.8k ohms at 12-VDC Check the voltage at both positive leads at the connection to the heater control module.
If voltage is not present, repair the wiring harness. If voltage is present, replace the heater control module.