C Series Intake Manifold Air Heater Temperature Sensor Section 10 - Air Intake System - Group 10 Page 10-35 Intake Manifold Air Heater Temperature Sensor (010-123) Initial Check The intake air temperature sensor is located in the intake manifold. Disconnect the harness connector from the temperature sensor. Resistance Check Use an ohmmeter to measure the resistance between the two pins of the intake air temperature sensor. If the resistance is not correct, replace the sensor. If the resistance is correct, the sensor must be checked for a short to ground. The resistance value is temperature-dependent.
Measure the resistance from each pin of the intake air temperature sensor to the engine block. The ohmmeter must show an open circuit (more than 100k ohms). If the circuit is not open, replace the sensor. Temperature (°C) Temperature (°F) Acceptable Resistance Range (ohms) 0 32 30k to 36k 25 77 9k to 11k 50 122 3k to 4k 75 167 1350 to 1500 100 212 600 to 675