Intake Manifold Air Heater Control Module C Series Page 10-40 Section 10 - Air Intake System - Group 10 Post Heat Cycle Connect the positive lead of the multimeter to the heater element terminal. Ground the negative lead to the engine block. Attach a multimeter to the heater wires. Clamp the ammeter current probe around both wires to the air heater. Before starting the engine, allow the preheat cycle to operate. Verify the voltage and amperage are cycling on and off according to the Heater Cycle Chart for Post Heat Cycle. Start the engine. Refer to the Intake Manifold Air Heater System General Information in Section F to verify the proper cycle.
The intake manifold temperature must be below 35°C [95°F] for the air heater to operate.