Cummins — 3666003

Air Compressor C Series Page 12-6 Section 12 - Compressed Air System - Group 12 Install Air Compressor Timing (for Single-Cylinder Air Compressor Only). Rotate the engine so that the number 1 cylinder is at top dead center (TDC) on the compression stroke. This is done by aligning the timing mark on the fuel pump gear with the TDC mark. NOTE: There are two similar marks on the air compressor gear that look like “[I]” and “I”. The timing mark to be used when timing the air compressor to the engine is “I”.

Cummins® Single-Cylinder AirCompressors Viewing the compressor from the gear end (with the compressor in a vertical position), rotate the gear so the “I” timing mark is at the 3-o'clock position. The Cummins® single-cylinder air compressor will have a divot on the housing at the 3-o'clock position to aid in timing the compressor. Once the timing mark is at the 3-o'clock position, this will set the compressor at 60-degrees before top dead center of the compressor's compression stroke. Air Compressor Timing (for Single-Cylinder Air Compressor Only, Other than Holset® or Cummins®) Locate TDC on the compressor crankshaft by removing the unloader valve or head.

(Refer to the air compressor manual.) TDC does not have to be exact. The system is tolerant of some misalignment.