Cummins — 3666003

C Series Engine Run-in (Without Dynamometer) Section 14 - Engine Testing - Group 14 Page 14-9 Operate the engine at torque peak rpm and full load for 4 minutes. Check all of the gauges, and record the readings. NOTE: Refer to the engine data sheet for the torque peak rpm of the engine model being tested. Operate the engine at rated speed (rpm) and full load for 4 minutes. Check all of the gauges, and record the readings. Compare the readings to those published on the appropriate engine data sheet. CAUTION Do not shut off the engine immediately after the run-in is completed. Allow the engine to cool by operating it at low idle for a minimum of 3 minutes to avoid internal component damage.

Make sure to remove all dynamometer instrumentation from the vehicle. Engine Run-in (Without Dynamometer) (014-004) Test On-Highway Applications Refer to Chassis Dynamometer - General Engine Test before operating the engine to avoid internal component damage. CAUTION Operate the engine at 1500 to 1800 rpm in high gear for the first 80 to 160 km [50 to 100 mi] after rebuild. CAUTION Do not idle the engine for more than 5 minutes at any one time during the first 160 km [100 mi] of operation.