Cummins — 3666003

C Series Crankcase Blowby, Measure Section 14 - Engine Testing - Group 14 Page 14-17 Crankcase Blowby, Measure (014-010) General Information Excessive crankcase blowby can indicate an engine or engine-related component malfunction that allows combustion gases or air to enter the crankcase. This results in the buildup of higher than normal crankcase pressure, which results in increased levels of blowby. This procedure describes how to measure crankcase blowby and how to determine what component is malfunctioning. Blowby is typically measured for the following situations:

Verifying engine break-in after an engine rebuild Troubleshooting for excessive lubricating oil out of the crankcase breather tube, commonly referred to as oil carryover (for open crankcase ventilation systems) Troubleshooting oil in the air intake system (for closed crankcase ventilation systems) Troubleshooting high crankcase pressure (for engines equipped with a crankcase pressure sensor) Troubleshooting possible internal engine damage (worn piston rings, valve stem seals, or guides, turbocharger, air compressor, etc.). NOTE:

For specific crankcase gases (blowby) symptom information and direction, reference the Crankcase Gases (Blowby) Excessive troubleshooting symptom tree in Section TS of the appropriate engine service manual. The following measure step will give general guidelines for measuring blowby relative to the above situations. NOTE: Some illustrations in this procedure do not show actual engine configurations. However, the procedure is the same.