Crankcase Blowby, Measure C Series Page 14-18 Section 14 - Engine Testing - Group 14 It is important to note that the terms blowby and carryover (oil out of the breather tube) are commonly used interchangeably. When measuring blowby, and there is an excessive amount of oil coming out of the breather tube, the quantity of oil can affect the blowby measurement. The blowby measurement is affected by the oil collecting on the orifice of the blowby measurement service tool. This reduces the size of the orifice, which results in higher than actual blowby measurements. If this occurs, it will be necessary to:
Find a different location on the engine to measure blowby (oil fill, oil fill cap, unused turbocharger drain location, etc.) Clean any oil residue from the breather and dry thoroughly before measuring blowby Determine if there is an issue causing the breather to be flooded with oil, for example: Incorrect oil level Vehicle operation (excessive angularity, excessive engine side-to-side movement) Internal engine components deflecting oil toward the breather cavity (piston cooling nozzles, accessory oil drains, etc.) Determine if another breather option is available for the engine being serviced. The tools used to measure blowby are similar in design.
The difference between the tools is in the size of the orifice. Different size orifices are available to more accurately measure blowby by accommodating the wide variety of engine configurations and ratings. This is due to the fact that engine blowby is dependent on the volume of intake airflow. For example: If measuring blowby on two identically configured and sized engines, but the horsepower ratings and rated speed are different, the maximum blowby values measured will be different. The engine with the higher horsepower rating and rated speed will have a higher volume of intake airflow, which will result in higher blowby.
This means that if the smaller orifice blowby tool was used on the engine with a higher horsepower rating and rated speed, the measurement can exceed the limits of the pressure measuring tool. To measure the crankcase blowby pressure, connect a water manometer, Part Number ST1111-3, or equivalent, pressure gauge, or transducer to the blowby tool. NOTE: Water manometer, Part Number ST1111-3, can measure a maximum of 944 mm [36 in] of water. Blowby Tool Part Number Orifice Size mm [in] 3822476 5.61 mm [0.221 in] 3822566 7.67 mm [0.302 in]