Cummins — 3666003

Flywheel Housing, REPTO C Series Page 16-36 Section 16 - Mounting Adaptations - Group 16 Install two crankshaft locator studs, Part Number 3822784, into the crankshaft flywheel mounting flange 180 degrees apart. Make sure the crankshaft and crankshaft gear is clean. Install the crankshaft gear in the locator studs. NOTE: Do not use any kind of lubricant to install the seal. The oil seal must be installed with the crankshaft gear seal contact surface and the lip of the seal clean and dry to provide a proper oil sealing surface. Install a new gasket (1) in the flywheel housing. Install a new seal over the crankshaft gear seal contact surface.

Apply sealant, Part Number 3375066, to seal retainer capscrews. Install the capscrews, and tighten in a star pattern. Torque Value: Step 1 7 N•m [ 60 in-lb ] Step 2 19 N•m [ 170 in-lb ]