Cummins — 3666003

C Series Flywheel Ring Gear Section 16 - Mounting Adaptations - Group 16 Page 16-37 Flywheel Ring Gear (016-008) Preparatory Steps Remove the transmission. Refer to equipment manufacturer's instructions. Initial Check Inspect the ring gear teeth for cracks and chips. NOTE: If the ring gear teeth are damaged, the ring gear must be replaced. Remove The component weighs 23 kg [50 lb] or more. To reduce the possibility of personal injury, use a hoist or get assistance to lift the component. WARNING Remove the flywheel. Refer to Procedure 016-005. To reduce the possibility of severe eye damage, wear eye protection when you drive the gear from the flywheel. Do not use a steel drift pin.

WARNING Use the brass drift pin to drive the ring gear from the flywheel.