Flywheel Ring Gear C Series Page 16-38 Section 16 - Mounting Adaptations - Group 16 Install Heat the new ring gear for 20 minutes in an oven preheated to 127°C [260°F]. WARNING To reduce the possibility of severe burns, wear protective gloves when installing the heated gear. NOTE: The ring gear must be installed so the bevel on the teeth is toward the crankshaft side of the flywheel. Install the ring gear. Use two capscrews and the barring tool, Part Number 3824591, in the front of the crankshaft to hold the crankshaft when the flywheel capscrews are being tightened. Tighten the capscrews in the sequence shown. Torque Value: 137 N•m [ 101 ft-lb ]