C Series Propeller Shaft Section 16 - Mounting Adaptations - Group 16 Page 16-39 Engine Mounts (016-010) Inspect for Reuse Damaged engine mounts and brackets can cause engine misalignment. Drivetrain component damage will possibly result in vibration complaints. CAUTION Inspect all rubber-cushioned mounts for cracks or damage. Inspect all mounting brackets for cracks or damaged bolt holes. Propeller Shaft (016-025) General Information Improper alignment of the propeller shaft can result in many problems. Vibration is usually the first indicator. Failure of the shaft seal or stuffing box can also occur.
If damaged shaft seals, stuffing box, strut, cutlass bearing, or propeller are found, refer to an authorized OEM repair location. Preparatory Steps Shaft alignment is checked when isolators are replaced, adjusted, or any time excessive vibration has been noticed. Also, any time the vessel has been taken out of the water and stored or blocked minor changes can take place in the shape of the hull. The shaft is checked and realigned as necessary after the vessel has been placed back in the water. Out of Water Inspect the propeller shaft for debris and burrs. Clean the propeller shaft. Check that the shaft is centered in the opening of the stuffing box flange.
The specifications will vary by manufacturer. If any problems are noted, refer to an authorized OEM service location.