Propeller Shaft C Series Page 16-40 Section 16 - Mounting Adaptations - Group 16 Inspect the strut. Make sure the strut is mounted solidly to the hull. Check that the shaft is aligned with the cutlass bearing, and that the bearing is not worn. If any problems are noted, refer to an authorized OEM service location. A misaligned shaft will cause uneven wear of the cutlass bearing. If the strut or cutlass bearing needs to be repaired or replaced, refer to an authorized OEM service location. NOTE: Initially align the shaft out of the water using the following instructions, then perform a final alignment after the vessel is in the water.
Alignment Check that the shaft is centered in the opening of the stuffing box flange. Unbolt the propeller shaft coupling from the marine gear coupling. The faces of the marine gear (1) couplings and propeller (2) must be parallel.