Cummins — 3666003

Marine Vibration Isolator C Series Page 16-42 Section 16 - Mounting Adaptations - Group 16 Marine Vibration Isolator (016-026) General Information This illustration shows the different types of marine isolators, and the location of the snubber and corresponding gap used to determine loading of the isolator. 1 Top nut 2 Leveling stud 3 Adjusting nut 4 Jam nut 5 Snubber gap. Generally, it is recommended to replace isolators as a set, but the age of the isolators and the conditions that caused the damage need to be reviewed. Isolators of different designs should not be mixed in the same installation.

Initial Check Check that the rubber portion of the isolator is not cracked, damaged, or pushed out from the isolator housing. If the rubber is damaged, the isolator will need to be replaced. Check that the isolator is not fully compressed. If an isolator is in the fully compressed condition, there will be no clearance in the snubber gap. If only one isolator is compressed, then the loading of the isolators may be unbalanced. Reference the Install Section of this procedure for steps to balance the load. If the isolator is still compressed after adjusting the load, then the isolator will need to be replaced.

If two isolators that are diagonally across from each other are significantly more compressed or fully compressed, then the loading on the isolators is unbalanced. Reference the Install Section of this procedure for steps to balance the load. If two isolators that are both on one side of the engine or both at the front or rear of the engine are fully compressed, then the isolators will need to be replaced.