C Series Marine Vibration Isolator Section 16 - Mounting Adaptations - Group 16 Page 16-43 Check that the metal parts of the isolator are not damaged, cracked, bent, or warped. If they are, the isolator will need to be replaced. Check for excessive corrosion. If corrosion is enough to weaken the structure or impede the function of the isolator, it will need to be replaced. If an isolator is damaged or worn and less than one year old, check that the isolator part number is correct for the engine. Check that the isolator mounting base is parallel with the engine crankshaft centerline and that the stud is perpendicular to the base, when looking from the side of the engine.
The oil pan flange can be used as a visual reference. The engine support brackets must also be parallel. The alignment of the isolator base to the crank centerline should be within four degrees of parallel. The alignment of the isolator stud to the base should be within four degrees of perpendicular. Check that the isolator mounting base is parallel to the transverse crankshaft centerline and that the stud is perpendicular to the base when looking from the front or back of the engine. The engine support brackets must also be parallel. The alignment of the isolator base to the transverse crankshaft centerline should be within two degrees of parallel.
The alignment of the isolator stud to the base should be within two degrees of perpendicular. Check that the isolator mounting base is parallel to the crankshaft centerline when looking from the top of the engine. The alignment of the isolator base to the crankshaft centerline should be within two degrees of parallel.