I006081 Fig. 1. The electronically regulated diesel injection (EDC) is divided into 3 central system blocks. The sensors and switches (information providers, input) record the operating conditions at the engine and convert the various physical variables into electronic signals. In the control unit (processing), the information and the output signals are calculated in accordance with the stored map- ping fields and characteristic curve. The control unit contains microprocessors and memory units. The control unit incor- porates self-monitoring, the emergency running program and self-diagnostics. The actuators (outputs) convert the electronic output signals into mechanical variables.
In addition : A good power supply is required, so that the control unit can operate reliably. This comprises: 1 A Output signals (actuators) 2 A051 ECU, engine control unit 3 CAN CAN connection to tractor 4 and diagnostics interface 5 E Input signals (sensors) 919 .. 0101-1000 925 .. 1001- 934 .. 0101-1000 919 .. 1001- 928 .. 0101-1000 934 .. 1001- 922 .. 0101-1000 928 .. 1001- 922 .. 1001- 931 .. 0101-1000 925 .. 0101-1000 931 .. 1001- Item Designation 6 U Power supply The control unit is also connected to the CAN bus system of the tractor. Sensor signals are used for several purposes e.g.
engine temperature Transmission Control System (TMS) 7 High-pressure sensor Unswitched supply terminal 30 2000 - Overall system/engine A - General Switched supply terminal 15 Earth supply terminal 31 8 T002534 Version 1 04-09-2009 Diagnostics A - General Item Designation Item Designation 1 Power supply A Output signals (actuators) 2 Output stage A051 ECU, engine control unit 3 Micro-controller CAN CAN connection to tractor 4 EEPROM and diagnostics interface 5 Monitoring module E Input signals (sensors) 6 Signal pre-processing U Power supply 7 High-pressure sensor