Check Chassis Range! 2060 - Engine/fuel system A - General I006259 Fig. 12. High-pressure pumps deliver high fuel pressure and suppress fluctuations in the required drive torque. The high-pressure pumps are driven from the camshaft by roller tappets. On 4-cylinder engines the camshaft has 2 cam blocks, each with 2 cam lobes. This is because 2 cylinders take their supply from each high-pressure pump. On 6-cylinder engines the camshaft has 2 cam blocks, each with 3 cam lobes. This is because 3 cylinders take their supply from each high-pressure pump. The high-pressure pump drives are lubricated with engine oil. For this reason the Deutz common rail system is approved for use with RME.
19 T002075 Version 3 23-07-2009 D ANGER : After switching off the diesel engine, wait at least 30 seconds before starting any work on the fuel system! W ARNING : Ensure the utmost cleanliness! See Service Information 14/2007. The high-pressure pumps can be filled only if the primary pressure is greater than 1,7 bar Hydraulic segregation of the high-pressure chamber during suction 6 High-pressure pump (PF 45) The high-pressure pumps fulfil two functions. To draw in fuel To pump out fuel General conditions