922 .. 0101-1000 928 .. 1001- 922 .. 1001- 931 .. 0101-1000 925 .. 0101-1000 931 ..
1001- 0000 - Overall system/tractor B - Faults 05-10-2009 08.1.B0 B030 - Sensor, rear power lift position Position sensor not calibrated No control possible, operable only via external button Calibration code "8002" Fault code DIN brief description Cause Consequences Reference FENDIAS/Note 72 Fault code DIN brief description Cause Consequences Reference FENDIAS/Note 08.1.B0 B030 - Sensor, rear power lift position Position sensor not calibrated No control possible, operable only via external button Calibration code "8002" 08.1.B2 A039 - MFA, multifunction armrest Setpoint value potentiometer, rear power lift Setpoint value potentiometer not calibrated Setpoint values cannot be set, only position con- trol possible Calibration code "8001" 08.1.B3 X015 - External control socket External sensor not calibrated Default values are used 08.1.C0 A039 - MFA, multifunction armrest MFA not fitted No auto mode possible, operable only via external button 08.1.C1 A073 - Terminal (A4) Terminal not fitted Configuration cannot be changed 08.1.F0 Y077 [HKH] - Cut-off valve, rear EPC Valve does not report to V bus No actuation possible 08.1.F2 Y077 [HKH] - Cut-off valve, rear EPC Undervoltage (where U Valve moves to neutral and locks 08.1.F3 Y077 [HKH] - Cut-off valve, rear EPC Overvoltage, safe (where U > 18 V) Valve moves to neutral and locks 08.1.F4 Y077 [HKH] - Cut-off valve, rear EPC Valve actuator falls short (frequent cause:
brief control pressure dips or oil too viscous at very low tem- peratures) Valve moves to neutral and locks 08.1.F5 Y077 [HKH] - Cut-off valve, rear EPC High overvoltage (> 45V) Valve moves to neutral and locks 08.1.F6 Y077 [HKH] - Cut-off valve, rear EPC Output stage error Valve moves to neutral and locks 08.1.F7 Y077 [HKH] - Cut-off valve, rear EPC Position pickup sensor error Valve moves to neutral and locks Pilot pressure OFF 08.1.F8 Y077 [HKH] - Cut-off valve, rear EPC Valve actuator does not return to neutral position; frequent cause:
valve actuator mechanically jams (pilot control or main actuator) due to contamination in hydraulics area Valve remains deflected when engine is on, valve locks, pilot pressure OFF