B3.9, B4.5, B5.9 Industrial Fuel Filter (Spin-On Type) Section 5 - Maintenance Procedures at 500 Hours or 6 Months Page 5-7 It is necessary to turn the keyswitch to the ON position. Because the engine can start, be sure to follow all safety precautions. Use the normal engine starting procedure. CAUTION When using the starting motor to vent the system, do not engage the starter for more than 30 seconds, or starter damage will occur. Wait 2 minutes before starting the engine again. CAUTION Air can also be vented through the fuel drain manifold line by operating the starting motor. Low Pressure Fuel Line(s) NOTE: For engines equipped with Distributor type pumps equipped with bleed screws.
Open the bleed screw. NOTE: If the engine is not equipped with a bleed screw, loosen the fitting on the low pressure supply line to the injection pump. Once priming has been completed, tighten the fitting to the specified torque. Operate the hand lever until the fuel flowing from the fitting is free of air. Tighten the bleed screw. Torque Value: 9 N•m [ 80 in-lb ] Finishing Steps Operate the engine and check for leaks.