Cummins — 4021389

Lubricating Oil and Filters B3.9, B4.5, B5.9 Industrial Page 5-8 Section 5 - Maintenance Procedures at 500 Hours or 6 Months Lubricating Oil and Filters Drain Some state and federal agencies have determined that used engine oil can be carcinogenic and cause reproductive toxicity. Avoid inhalation of vapors, ingestion, and prolonged contact with used engine oil. If not reused, dispose of in accordance with local environmental regulations. WARNING WARNING To reduce the possibility of personal injury, avoid direct contact of hot oil with your skin. Change the lubricating oil and filter(s) at the specified oil change interval.

Refer to Procedure 102-002 (Maintenance Schedule) in Section 2 to find the correct change interval for your application. Operate the engine until the water temperature reaches 60°C [140°F]. Shut off the engine. NOTE: Use a container that can hold at least 26 liters [27 qt] of lubricating oil. Remove the oil drain plug from the bottom of the lubricating oil pan. Remove Clean the area around the lubricating oil filter head. Remove the oil filter. Clean the gasket surface of the filter head. NOTE: The o-ring can stick on the filter head. Make sure it is removed before installing the new filter.