John Deere 326D, 328D, 332D — Anti-Theft Security System Operation—If Equipped

Operation—Operator’s Station All security codes are three digit numbers that are entered using the MENU and SELECT buttons on the EMU. Unlock or lock prompts appear on the EMU display at machine power up or power down, respectively. If the anti-theft security system is not enabled on the machine, no prompts will appear. Auto Lock Feature The auto lock feature, when enabled, automatically locks the machine 5 minutes or 60 minutes after the operator leaves the seat if the machine had been left unlocked when turning key switch to OFF position. See Anti-Theft Security System Operation in this section, for further information.

See Anti-Theft Security System Operation in this section, for further information. OUT4001,0000503 -19-11APR11-2/2 Engagement and Monitor Unit Display Messages The engagement and monitor unit (EMU) automatically displays a message for specific machine situations and certain diagnostic trouble codes (DTCs). Depending on machine situation or if a DTC is initially active, a message displays on the EMU until the situation changes, the DTC is resolved, or the operator presses any button on the EMU. If multiple display messages are generated, the one with the highest EMU priority displays.

Pressing any button on the EMU closes the displayed message, allowing the next message to display in order of EMU importance until all generated messages have been displayed. OUT4001,0000506 -19-23NOV10-1/1 2-1-7 071713 PN=38 Display Message Message Trigger A/C OFF Air conditioning has shut off because engine temperature is greater than 108°C (226°F). Auto Idle Auto Idle is active. Aux Hydraulic Bypass Auxiliary hydraulics are in override mode. Check Service Code A DTC is active that should trigger the Check Service Code monitor message. Door Open Operator attempted to release park brake without door closed (cab machines).

Operator attempted to move right joystick with door open and seat interlock OK (cab machines). Enable Hydraulics Operator attempted to move right joystick after engine startup and seat belt fastened, but before enabling hydraulics (using park brake switch). Engine Air Filter Restriction Engine air filter restriction warning indicator comes on and indicator not in bulb check. Engine Oil Pressure Low Engine oil pressure indicator light comes on after engine is running. Engine Temperature High Engine temperature goes to the red zone of gauge and the engine is running.

Fasten Seat Belt Lower Lapbar Operator attempted to release park brake without fastening seat belt and lowering interlocking seat bar. H Pattern Selected Pattern select option installed. H pattern steering and bucket control is active. High Voltage Battery voltage warning indicator comes on after engine is running and DTC is triggered. Hyd. Oil Filter Restriction Hydraulic oil filter restriction warning indicator comes on and indicator not in bulb check. Hydraulic Oil Temp. High Hydraulic oil temperature indicator light comes on and indicator not in bulb check. ISO Pattern Selected Pattern select option installed. ISO pattern steering and bucket control is active.

Left Joystick Not in Center Joystick is out of neutral when park brake has just been released. Low Fuel Fuel level low after engine is running. Low Voltage Battery voltage warning indicator comes on after engine is running and DTC is triggered. Precision Rate Selected Adjustable boom and bucket rate installed. Precision mode is active. Production Rate Selected Adjustable boom and bucket rate installed. Production mode is active. Release Park Brake Operator attempted to move left joystick after engine startup and seat belt fastened, but before releasing park brake (using park brake switch). Remote Start Connected Remote start box installed.

Return Joysticks To Center Appears when creep mode switch or pattern select switch is cycled. Right Joystick Not in Center Joystick is out of neutral when hydraulics are enabled. Set Park Brake To Start Engine The seat switch is active, the key switch is ON, and the engine is not running. (Park brake switch must be ON to start engine.) Utility Rate Selected Adjustable boom and bucket rate installed. Utility mode is active. Hydraulic Temperature Too Low For Shift Hydraulic oil temperature is below specification for two speed shift to occur. (318D and 320D only.)