. MAINTENANCE SERVICE PROCEDURE REPLACE HYDRAULIC TANK BREATHER ELEMENT WARNING then remove cap (1). 4 - 58 The parts and oil are at high te mperature immediately after the engine is stopped, and may cause burns. Wait for the ork. temperatur e to go down b efore st arting the w When remo ving the oil fill er cap, oi l may spur t out, so push t he cap down to release the internal pressure, then remove t he cap carefully. 1. Push do wn cap (1) of oil filler (F) to rele ase the air an d remove nal pressure. 2. Keep ca p (1) pushed 3. Remove ring (2) from inside t he lip of c ap (1). 4. Remove 5. Replace filter elemen 6. Install va lve (3) and ri ng (2) i n their ori ginal position 7.
Install ca stalling cap ( 1) to the tank, pu sh it down, th en tur n it REMARK not installed correctly, it will cause leakage of oil. If the cap is not installed correctl y, it will ca use leakage When install ing the cap, press th e cap do wn, and turn it until i t is securely in contact w ith the stopper. The cap is t he lock additi on type. About handl ing method o f cap wi th the loc k, see " CAP WITH