Komatsu — CHECK, CLEAN FUEL STRAINER

. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN FINAL DRIVE CASE WARNING ADD OIL (PAGE 4-55)". 4 - 59 The oil is at high temper ature immediately after the machine ha s been operated. Wait for the oil to co ol down before starting the operation. There is danger that oil spouts out due to the intern al pressur e. When removing the plug, work from the side, turn the plug slowly to release the int ernal pressure, and remove i t carefully. Refill capacity: rs (6.87US gal) rs (9.51US gal) D85EX : (each) 26 lite D85PX : (each) 36 lite 1. Stop the machine so that drain plug (H) is direc tly at the b ottom. 2. After removing oil fil ler/level plug (G), remove drain plugs (H) ain.

(H) and (1), drain the oil , then tighten the plug ag 3. Add the replacement amount of oil through the hole of pl ug (G). 4. After adding oil, chec k that the oil is up to to th e specifie d level. For details, see "CH ECK OIL LEVEL IN FINA L DRIVE CASE, CHECK, CLEAN FUEL ST RAINER lve (1), then remove strainer cap (2). ne unit with the strainer cap. 1. 2. 3. 4. 1. Close fuel supply va lve (1), then remove strai ner cap ( The strainer forms o ne unit with the strainer c Remove any dirt stuc k to the strainer, then wa sh in clean diesel fuel or flushing oil. If After checking and c the strainer is damaged, leaning, set the strainer i replace it n the cas . e, then tighten cap (2).

fuel supply valve (1). 4. After installing, open