Komatsu — CHECK TIGHTENING PARTS OF TURBOCHARGER

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE NOTICE holder. Bleed the air as follows: 4 - 61 Do not fill the fuel filter ca Remove cap (B) and insta 4. Clean the filter holder, coat the packing surface of t he new filter cartridge thinly with oil , then install the filter cartridg e to the filter 5. When installing, tighte n until the packing surface c ontacts the seal surface o f the filter holder, the n tighten it 3/4 of a turn. If the filter cartridge is tightened too far, the packin g will b e damaged and th is will lead to leakag e of fuel. If the filter cartridge is too l oose, fuel will also leak from t he packing , so always tig hten the correct am 6.

Open the cock(1) and loosen air bleeding plug (3). and down, 7. Loosen the knob of p rimimg pump (4), move it up own, 8. and continue until no air bleed plug (3). Tighten air bleed plug more bubbles come out with the fuel from (3), push in the knob of priming pump (4), 9. then tighten it. After replacing the filt for leakage from the f er cartridge, start the engine and check ilter seal surface. REMARK When only the filter cartri dge is replaced, it is suffficien t that a ir bleeding is carri ed out for the filter he ad alone. But when the fuel piping is re moved, air bleeding should a lso be carried out for the injection pump air-bl eeding valve.

CHECK TIGHTENING PARTS OF TURBOCHARGER Contact your Komatsu di stributor to have the tightenin g portions c