. MAINTENANCE SERVICE PROCEDURE REPLACE CORROSION RESISTOR CARTRIDGE WARNING 4 - 62 If the engine has been operat ed, all parts will be at a high te mperatu re, so never try to replace the cartr idge immediately after stopping the engine. Always wait for the engine an Container to catch drain ed coolant or fuel filter element. sion resistor (1) as far as the CLOSE h the coolant under the cartridge. Prepare a filter wrench f 1. Turn valve (2) of corro stopper. 2. Set a container to catc 3. Using a filter wrench, t 4. Clean the filter holder, the new cartridge with 5.
When installing, tighte seal surface of the filte If the filter cartridge is damaged and this will If the filter cartridge is t packing, so always tig 6. Turn valve (2) of the c 7. After replacing the cart coolant leakage from leakage, check if the c 2. Set a container to catc 3. Using a filter wrench, t 4. Clean the filter holder, urn cartridge (3) to the left to coat the packing surface an remov d threa e it. d of oil, then install it to the filter n until the packing surface c holder. ontacts the r holder, then tighten it up 2/ 3 of a t urn. tightened too far, the pack ing will be lead to leakage of coolant. oo loose, coolant will also le ak from the hten to the correct amount. n. 6.
Turn valve (2) of the c artridge to the OPEN positio 7. After replacing the cart ridge, start the engine and ch eck for any the filter seal surface. If th ere is any . any artridge is tightened properly