. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE 4 - 65 2. Remove the undercover (1) at the bottom rear of the ch assis as follows. 1) Remove 2 bolts (2) 2) Hold cover (1) in pos at the Left of mach doing this.) 3) Lower cover (1) slow right side of the cove Drain plug (P) can b follows. at the Right of machine. 1) Remove 2 bolts (2) 2) Hold cover (1) in pos ition and gradually remove 2 bolts (3) ine. (Rain water may flow out when 3) Lower cover (1) slow ly to open it. (There is a hing e on the r.) e seen at the top. 3. Remove dipstick (G), the n remove drain plug (P) and drain the oil. After draining the oil,tigh 4. Add oil through the hold insert dipstick (G).
er of dipstick (G). After adding the oil, the breather (4). 5. 6. Wipe away dust around Remove breather (4). 7. Remove any dirt or dust stuck to breather (4), then w ash w ith clean diesel oil or flu shing oil.If it cannot be cleaned a new part. cleaned completely, replace with 8. Install the breather (4). Then close cover (1). 9. CHECK PIVOT BEARING OIL LEVEL, ADD OIL 1. Remove plug (1). 2. Check that the oil is at th e level shown in the diagram. If the oil level is low, add oil throu Use class TO30 (SAE 3 gh the hole of plug (1). 0) engine oil regardless of the ambient temperature.