OPERATION SECURITY LOCKS AND SAFETY FEATURES This machine is equipped with several security locks and safety features designed to protect the operator, persons performing service, repair, or inspections on the machine, as well as the general public when the machine is not in use and unattended. It is important for the operator of the machine to know where these features are located and when to use them. Failure to do so may result in damage to the machine or injury to personnel. Steering Tilt Lock Lever Stop the machine before adjusting the tilt of the steering wheel.
If this operation (adjustment) is carried out while the machine is moving, it may lead to a serious accident or personal injury. The steering tilt lock lever is used to hold the steering wheel in position. (F) position: FREE Steering wheel can be moved to front, rear, up, and down. (L) position: LOCK Steering wheel is held in position. The amount of adjustment is shown in the following table. Remark Do not operate lever (1) continuously by excessive force. The lever (1) may become loose or get out of angle. In this case, please ask your Komatsu distributor to carry out repairs. Bolts (2) and (3) on the steering column are left hand screws.
If they are screwed counterclockwise, it is not a loosening direction but a tightening direction (A). 2-64 WA430-6 Up-Down Movement When at 0 mm (0 in) When Moved up to 40 mm (1.6 in) Tilt amount 0 - 105 mm (0 - 4.1 in) 0 - 130 mm (0 - 5.1 in)