Adjusting Mirrors OPERATION Be sure to adjust the mirrors before starting work. If the mirrors are not adjusted properly, you cannot ensure good visibility. The lack of adequate visibility could result in serious injury to you or anybody in the vicinity of the machine. Mirrors A, B Loosen bolt (1) of the mirror, then adjust the mirror to a position which gives the best view from the operator’s seat of the blind spot at the left and right sides at the rear of the machine. When installing the mirror, adjust so that it is possible to see any person (or any object of a height of 1 m (3 ft 3 in) and diameter of 30 cm (11.8 in)) at the rear left or right of the machine.
Mirrors C Adjust so that is possible to see the ground around the machine at a range of 1 m (3 ft 3 in) from the operator’s seat. If the movement of the mirror is stiff when adjusting it, loosen bolt (2) of the mirror. Install the mirrors at the position and dimensions shown in the diagram. The following values are reference values for the range of visibility. Range of view (left): . . . . . . . . . . . . . . . . . . . . . . .2500 mm (8.20 ft) Range of view (right): . . . . . . . . . . . . . . . . . . . . .2500 mm (8.20 ft) Mirror A: . . . . . . . . . . . Must be possible to see hatched portion (A) Mirror B: . . . . . . . . . . . Must be possible to see hatched portion (B) Mirror C: . . . .
. . . . . . . Must be possible to see hatched portion (C) Tighten the mirror mounting bolts securely so that they do not loosen and the mirrors do not come off. Tightening torque: Mirrors A, B: . . . . . . . . . . . . . . . 2.0 – 2.5 N•m (17.70 – 22.13 lbf in) Mirrors C: . . . . . . . . . . . . . . . . . 8.8 – 9.8 N•m (77.89 – 86.74 lbf in) If the tightening torque cannot be controlled, ask your Komatsu distributor to tighten the bolts. WA430-6 2-95