Komatsu — Normal Operation

Breaking in the Machine OPERATION Your Komatsu machine has been thoroughly adjusted and tested before shipment. However, operating the machine under severe conditions at the beginning can adversely affect the performance and shorten the life of the machine. Be sure to break in the machine for the initial 100 hours (as indicated by the service meter). During breaking-in operations, follow the precautions described in this manual. Idle the engine for five minutes after starting. Avoid operation with heavy loads or at high speeds. Immediately after starting the engine, avoid sudden starts, sudden acceleration, unnecessary sudden stops, and sudden changes in direction.

Normal Operation After starting the engine, do not immediately start operations. First, carry out the following operations and checks. Remark Do not suddenly accelerate the engine before the warming-up operation is completed. Do not run the engine at low idle or high idle continuously for more than 20 minutes. If it is necessary to run the engine at idle, apply a load from time to time or run the engine at a mid-range speed. 1. Depress accelerator pedal (1) lightly and run the engine with no load at mid-range speed for about five minutes. 2. Carry out the following operation to warm up the hydraulic oil in cold areas. A.

Operate the bucket control lever to the TILT position (A) and return it to the HOLD position (B) repeatedly to warm up the hydraulic oil. B. Relieve the circuit at the TILT position (A) for a maximum of 10 seconds. This brings the oil to the relief pressure and makes it faster to warm up the oil. C. Slowly operate the steering wheel to the left and the right about ten times to warm up the hydraulic oil inside the steering valve. WA430-6 2-103