Komatsu — Normal Operation

OPERATION If the steering wheel is operated and stopped while the oil temperature is low, there may be a time lag before the machine stops turning. In this case, use the frame lock bar to ensure safety, and perform the warm-up operation in a wide place. Do not relieve the hydraulic oil in the circuit continuously for more than five seconds. Remark Turn the steering wheel a little and stop in that position. Confirm that the machine turns by an angle equivalent to the amount that the steering wheel is turned. 3. After carrying out the warming-up operation: Check that the engine rotation is smooth. Set the work equipment lock lever to the FREE position (F). 4.

After carrying out the warming-up operation, check that the meters, gauges, and pilot lamps work properly. If any abnormality is found, carry out maintenance or repair. 5. Run the engine under a light load until engine coolant temperature gauge (2) and torque converter oil temperature gauge (3) are in the green range. 6. Check for abnormal exhaust gas color, noise, or vibration. If any problem is found, contact your Komatsu distributor. The rotating speed of the cooling fan changes according to the following conditions; this does not indicate any abnormality.

If the hydraulic oil temperature, engine coolant temperature, or transmission oil temperature are high, the rotating speed of the cooling fan increases. When the cooling fan is rotating in reverse, it rotates at a fixed speed proportional to the engine speed, regardless of any oil or coolant temperature. 2-104 WA430-6