OPERATION Changing Direction When changing direction between FORWARD and REVERSE, check that the new direction of travel is safe. There is a blind spot behind the machine. Be particularly careful when changing direction to travel in reverse. Do not switch between FORWARD and REVERSE when traveling at high speed. When switching between FORWARD and REVERSE, depress the brake to reduce the travel speed sufficiently and then change the direction of travel. (Maximum speed for changing direction: 13 km/h (8.1 mph)) When coasting down a slope, set the directional lever to match the direction of travel of the machine.
If the directional lever is in the opposite direction to the direction of travel, there is danger that the engine may stall. This condition is extremely dangerous. There is no need to stop the machine even when switching between FORWARD and REVERSE. Place directional lever (1) in the desired position. Position (F): Forward Position (N): Neutral Position (R): Reverse Check that the backup alarm sounds when the directional lever is set to REVERSE. If the backup alarm does not sound, contact your Komatsu distributor for repairs.
Remark If the directional lever is operated slowly or is stopped midway between the forward and reverse directions, “E01 MAINTENANCE” may be displayed on the character display. In this case, there is no failure. Try to operate the directional lever so that the change in direction is completed within two seconds. If an attempt is made to switch the direction between FORWARD and REVERSE while traveling at high speed (when using 3rd or 4th) when the travel speed and engine speed are in ranges (A) or (B) in the chart, the central warning lamp will light up and the alarm buzzer will sound. At the same time, “OVERRUN PROTECT” is displayed on the bottom line of the character display.
If the alarm buzzer sounds, depress the brake pedal immediately to reduce speed, then operate the directional lever to switch between FORWARD and REVERSE. (X): Travel speed (km/h) (Y): Engine speed (rpm) 2-110 WA430-6