OPERATION Emergency Steering (if equipped) Do not actuate the emergency steering except in emergencies. The emergency steering does not work when the machine is stopped. The emergency steering can be used continuously for a maximum of 60 seconds. Operating it continuously for more than 60 seconds may damage the system. When using the emergency steering, travel at less than 5 km/h (3.1 mph). If the steering becomes stiff, keep the emergency steering switch pressed; move the machine immediately to a safe place; then stop the machine. On machines equipped with an emergency steering function, the emergency steering switch (1) is installed at the position shown in the graphic.
During emergencies or when stopping the engine to check the function, press emergency steering switch (1). Emergency steering pilot lamp (green) (2) illuminates to indicate that the emergency steering system has been actuated. It is now possible to operate the emergency steering. This system enables the machine to be steered under the following conditions: The starting switch is at the ON position. The steering oil pressure is low or there is no pressure. (When the engine has stopped or there is a failure in the steering oil pressure pump, etc.) When the starting switch is turned to the ON position, the emergency steering automatically carries out a self-check for three seconds.
For details, see “Emergency Steering Self-Check Function” on page 2-117. When the emergency steering controller detects a lack of oil pressure in the steering system, steering oil pressure caution lamp (red) (3) and central warning lamp (4) illuminate, and the alarm buzzer sounds intermittently. If this happens and the machine is traveling at a speed of more than 2 km/h (1.2 mph), the emergency steering pump is automatically actuated and emergency steering pilot lamp (green) (2) illuminates. Steering oil pressure caution lamp (red) (3) illuminates to indicate that the steering system has failed.
If the steering oil pressure caution lamp (red) (3) illuminates, move the machine immediately to a safe place; stop the machine; stop the engine; and carry out inspection. Do not operate the machine until the problem has been removed. Remark If any function of the oil pressure system is used when the engine is running at low speed, steering oil pressure caution lamp (red) (3) may light up momentarily. This is only for a moment and does not indicate a problem. When the emergency steering controller detects that the oil pressure in the steering circuit has been restored, the actuation of the emergency steering system is stopped. 2-116 WA430-6