OPERATION Precautions During Work Operations Piling Up Loads When forming products into a pile, be careful not to let the rear counterweight come into contact with the ground. Do not set the bucket to the DUMP position when piling up loads. Remark As much as possible, do not use the transmission cutoff function during scraping-up operations. This will prevent the machine from rolling back. When using the transmission cutoff function, lower the cutoff position so that the cutoff function is actuated when the brake pedal is pressed hard, while ensuring ample braking force.
Handling Blasted Rock If the target load is blasted rock, pay careful attention to the following items when carrying out the operation in order to extend the service life of the machine. Handling Bucket When approaching the facing and lowering the bucket to the ground, do not drop the bucket suddenly into contact with the ground. If the bucket is dropped suddenly, the bucket, work equipment, area around the pins, and the machine frame will be subjected to excessive shock. This will lead to damage or deformation of various parts of the machine. In addition, the front wheels will come off the ground and cause the machine to slip.
When lowering the bucket to the ground, reduce the lowering speed of the bucket when it is close to the ground and bring it slowly into contact with the ground. Shifting Transmission When Thrusting Bucket Into Facing When thrusting the bucket into the facing to carry out excavation, do not shift down with the accelerator pedal depressed (with the engine speed raised). If the transmission shifts down when the engine speed is high, there will be an excessive load on the engine, torque converter, transmission, axles, final drive, and the whole power train.
When shifting down to 1st and thrusting the bucket into the facing, release the accelerator pedal to reduce the engine speed before shifting down and then gradually depress the accelerator pedal. If the accelerator is operated suddenly after shifting down, there will be excessive load brought to bear on the engine and power train. 2-132 WA430-6