Komatsu — Handling Blasted Rock

Articulating Machine During Digging Operations OPERATION Do not carry out operations with the machine articulated. If the machine is articulated, the direction of force will be different for the front wheels and rear wheels. As a result, the power, when traveling, will not be transmitted fully to the front wheels. This will reduce the digging force and bring an excessive load to bear on the center hinge pin. In addition, even with the front wheels, the power will not be transmitted uniformly to the left and right wheels. The load will be brought to bear on one wheel thus reducing the service life of the tire on one side.

If digging work is carried out with the machine articulated, the overall stability of the machine will be poor. There is danger of the machine tipping over. When carrying out operations, do not articulate the machine. Drive straight forward and thrust the bucket in. If this is done, the load on the bucket will be uniform. This makes it possible to avoid load on one side and makes it easier to load the bucket. Bucket Dump Angle When Digging or Lowering Roadbed Do not set the cutting edge of the bucket at a large angle to the ground surface when digging or lowering the roadbed. Keep angle (a) between the bucket and the ground surface to a maximum of 8°.

If angle (a) between the cutting edge of the bucket and the ground surface is more than 8° when digging or lowering the roadbed, there is danger of damage to the work equipment. Bucket Dump Angle When Leveling Drive the machine in reverse when carrying out leveling operations. WA430-6 2-133