Komatsu — Parking the Machine

Parking the Machine OPERATION Avoid stopping suddenly. Give yourself ample room when stopping. Do not park the machine on a slope. If the machine must be parked on a slope, set it facing directly down the slope; dig the bucket into the ground; and put blocks under the tires to prevent the machine from moving. If the work control lever is touched by accident, the work equipment or the machine may move suddenly. This may lead to a serious accident. Before leaving the operator’s compartment, always set the work equipment lock lever securely to the LOCK position. When the parking brake switch is turned ON, it is dangerous to release the brake pedal immediately.

Always keep the brake pedal depressed until the parking brake pilot lamp illuminates. Remark Never use the parking brake switch to brake the machine when traveling, except in an emergency. Apply the parking brake only after the machine has stopped. Park the machine on firm, level ground. If the machine must be parked on a slope, set it facing directly down the slope; dig the bucket into the ground; and put wheel chocks (see “WHEEL CHOCKS” on page 5-39) under the tires to prevent the machine from moving. Select a place where there is no hazard of landslides, falling rocks, or flooding. 1. Release accelerator pedal (1) and then depress brake pedal (2) to stop the machine. WA430-6 2-149