Komatsu — Clean Inside of Cooling System

MAINTENANCE 14. Bleed the air from the cooling system. Run the engine at low idle for five minutes, than for a further five minutes at high idle. (This removes the air from the coolant.) Make sure that the radiator cap is off. 15. Drain the coolant inside the subtank (4) and clean the inside of the subtank. 16. Add water to the subtank to a point midway between the FULL and LOW marks. 17. Stop the engine and wait for three minutes. 18. Add coolant to the radiator until the coolant level is near the coolant filler port, then tighten the cap. Check the coolant level and add coolant, if necessary. 19. Replace the radiator cap and tighten it. 3-36 WA430-6