Komatsu — Turn, Replace Bolt-On Cutting Edge

Turn, Replace Bolt-On Cutting Edge MAINTENANCE It is dangerous if the work equipment moves by mistake during the turning or replacement operation. Set the work equipment on a stable position; stop the engine; then set the work equipment lock lever securely to the LOCK position to lock the work equipment control levers. Turn or replace the cutting edge before the wear reaches the edge of the bucket. 1. Raise the bucket to a height greater than the height of the blocks (A). 2. Set the bucket so that the bottom of the bucket is horizontal to the blocks (A) and then lower the bucket so that the center of the bucket rests on the blocks. 3. Stabilize the bucket and then stop the engine. 4.

Set the work equipment lock lever to the LOCK position (L). 5. Remove nuts and bolts (1), then remove cutting edge (2). 6. Clean the mounting surface of cutting edge (2). 7. Turn cutting edge (2) and install it to the bucket. When turning the edge, install it to the opposite side (left edge to right side, right edge to left side). If both sides of the cutting edge are worn, replace with a new part. If the wear extends to the mounting surface, repair the mounting surface before installing the cutting edge. 8. Tighten nuts and bolts (1) uniformly so that there is no gap between the bucket and cutting edge. Tightening torque for mounting bolt: . . . . . . . . . . . . . . . . . . . . . . . . . .

. . . 745 ±108 N•m (550 ±80 lbf ft) 9. Tighten the mounting bolts again after operating the machine for several hours. WA430-6 3-45