Komatsu — Replace Bucket Teeth (if equipped)

MAINTENANCE Replace Bucket Teeth (if equipped) It is extremely dangerous if the work equipment moves when the teeth are being replaced. Set the work equipment in a stable position; stop the engine; and set the work equipment lock lever securely to the LOCK position to lock the work equipment control levers. If the pin is hit with a strong force, there is danger that the pin may fly out. Check that there is no one in the surrounding area. There is danger of pieces flying during the replacement operation. Always wear protective clothing, such as safety glasses and gloves. One-Piece Tooth Remark Replace bucket teeth before they wear down as far as the bucket edge. 1.

Raise the bucket to a height greater than the height of the blocks (A). 2. Set the bucket so that the bottom of the bucket is horizontal to the blocks (A) and then lower the bucket so that the center of the bucket rests on the blocks. 3. Stabilize the bucket and then stop the engine. 4. Set the work equipment lock lever to the LOCK position (L). 5. Remove the bolt (1) and nuts (2), and then remove bucket tooth (3). 6. Clean the installation surface of the bucket tooth. 7. If the mounting surface is worn, correct the mounting surface before installing the tooth. 8. Install the new tooth to the bucket.

When doing this, insert shims so that there is no clearance between the tooth and the top surface of the bucket. Continue to add shims until it becomes impossible to add a 0.5 mm (0.02 in) shim. 9. To prevent any gap from forming between the tooth and tip of the bucket, tighten bolts (1) and nuts (2) temporarily, and then hit the tip of the tooth with a hammer. Tightening torque: (1): . . . . . . . . . . . . . . . . . . . . . . . . . 637 ±853 N•m (470 ±629 lbf ft) (2): . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 618 N•m (456 lbf ft) 10. After operating the machine for a few hours, tighten the mounting nuts again. 3-46 WA430-6