Komatsu — Replace Bucket Teeth (if equipped)

Bucket with Tip Tooth MAINTENANCE It is dangerous if the work equipment moves by mistake when the teeth are being replaced. Set the work equipment in a stable position; stop the engine; and lock the work equipment control levers securely with the work equipment lock lever. If the pin is hit with a strong force, there is danger that the pin may fly out. Check that there is no one in the surrounding area. There is danger of pieces flying during the replacement operation. Always wear protective clothing, such as safety glasses and gloves. Remark Replace the teeth before they wear down as far as the adapter. 1. Raise the bucket to a height greater than the height of the blocks (A). 2.

Set the bucket so that the bottom of the bucket is horizontal to the blocks and then rest the center of the bucket on the blocks. 3. Stabilize the bucket and then stop the engine. 4. Set the work equipment lock lever to the LOCK position (L). 5. Remove pin (2) installed to the bucket, then remove tooth (1). Use a rod (slightly narrower than the pin) in contact with the hatched portion (either left or right) and tap pin (2) out to the opposite side. Remark If the tooth cannot be removed by this method, for safety reasons always contact your Komatsu distributor to have the replacement carried out. WA430-6 3-47